| After-sales Service: | Yes |
|---|---|
| Warranty: | 1 Year |
| Standards: | IEC 60332 |
| Operating Voltage: | AC220 V ± 10V 50Hz |
| Ambient Temperature: | Room Temperature ~ 40 ºC |
| Gas Pressure: | 0.1MPa |
| Customization: |
|---|
Suppliers with verified business licenses
Audited Supplier 
IEC 60332 Single Wire and Cable Vertically Flame and Fire Tester is used to assess the flame retardant performance of the wire and cable insulation layer under abnormal conditions such as high heat and current. It can be used to test the vertical flame spread of cable or cable, as well as the burning condition of dew under flame conditions.
The customized design of this tester meets the design requirements of iec60332-1 and an iec60332-2 blowtorch, according to customer requirements. Test a control system set that includes two sets of test boxes and a dustproof function. The experiment should be open, according to the standard requirements.
Wire and Cable is second-largest industry. Single wire and cable vertical burning tester is the most widely used and low cost of cable fire performance test equipment. Single wire or cable burning tester meet the national standard GB /T18380.11-2008 / IEC60332-1-1: 2004 requirement. It is to test flame retardant insulation layer under fire conditions applicable for testing wire and cable in overheating, over-current and other non-normal state. It can be used for vertical or fiber optic wire and cable flame spread test,and test combustion conditions of Dettol matter under fire conditions.
1. Touch screen intelligent control system; English user interface.
2. Automatic ignition system, automatic timing, automatic data storage.
3. The test section and the control section is combined design in one box for operation.
4. Stainless steel test box, the internal cavity size: height 1200mm,width 300mm, depth of 450mm.
5. A pre-mixed burner, an inner diameter of ¢ 12 ± 0.5mm, length is 100mm. 1KW hybrid standard burner,which provides accurate test fire source.
6. The flame burning applied time and hold time can range from 0 to 99 minutes99 seconds range adjustment. Automatic control of the testing process.
7. Needle valve precisely adjust the flame height, according to standards, the blue flame height is 50mm ~ 60mm, total height 170mm ~ 190mm.
8. The gas flow rate is controlled by needle valve.
9. Equipped with a flame height caliper.
10. Equipped with a gas flow meter and pressure regulator; automatic ignition.
11. The torch angle is 45 °, 0 ° adjustable.
12. The flame calibration device is optional.
Specifications are displaying in table:
|
Operating voltage |
AC220 V ± 10V 50HZ |
|
Ambient temperature |
room temperature ~ 40 ºC |
|
Gas Pressure |
0.1MPa |
|
Gas purity |
Propane> 95%; compressed air |
|
Timing Accuracy |
0.1s |
|
Model |
GD-IEC60332 |
|
Size |
600(W)×450(D)×1250(H)mm |
|
Power |
AC 220V, 50/60Hz, 3A |
|
Weight |
60kg |
|
Manual |
Provide |
Contact Person: Kiana Feng
Suppliers with verified business licenses
Audited Supplier 
){kind=link}
){kind=link}